Material and heat treatment of conventional parts

Positioning block: 45# heat treatment: aging treatment, hard chromium plating on the surface

Spacer: 2316 heat treatment: hrc48-52 (diameter less than) φ 16), for profile offset = 3mm And 5mm

Locating pin and sleeve: SKD11 heat treatment: hrc55-60, used for HRC hardness > 55 degrees

2316 heat treatment: hrc48-52 (diameter less than φ 16)

Simulation block: LY12 heat treatment: artificial aging treatment shall be conducted when the deformation of parts is too large after processing

7075 heat treatment: same as above (for the case of very poor strength of parts and high material price)

Renshape 470 resin is suitable for sheet metal parts and inspection tools with high precision requirements

Bm5166 resin is suitable for sheet metal parts and inspection tools with high precision requirements

Lab1001 resin is suitable for sheet metal parts and inspection tools with high precision requirements

Renshape 460 resin is suitable for carpets and inspection tools with low accuracy requirements

Base plate: LY12 / ZL104 heat treatment: Aging (cast aluminum ZL104)

Clamp support: LY12 / A3 steel (straight seat clamp support is usually welded with A3 steel)